 |
Share | New Products | Shopping Cart | Store Directory | |
1-800-633-3047 |
International Distributors | Contact Us | Testimonials | About Us |
Fast Patch Menu |
|---|
      |
Fast Patch Instructions
| We will demonstrate how to apply Urethane Supply Company's Fast Patch on a tear on a bumper and a hole on a bumper. |  |
| With a piece of paper, cut a template from a piece of paper. |  |
| Trace template onto the black side of the Fast Patch. |  |
| Cut the Fast Patch Panel with a pair of scissors. |  |
| Open the packet containing the Plastic Cleaner wipe and clean the area where the patch will be applied. |  |
| Once the cleaner has evaporated fully, open the packet containing the Adhesion Promoter and wipe the area where the patch will be applied. |  |
| With a heat gun, heat the patch until the edges begin to curl. If a heat gun is not available, bake the patch in an oven at 200°F (93°C) until the edges begin to curl. |  |
| While the patch is still hot and pliable, remove the red film from the adhesive and press the patch into place. |  |
| The more surface area that the patch has contact with, the stronger the repair will be. If you have some areas of the patch that did not get contact with the plastic, you can reheat the patch until it is pliable and press it into place. |  |
| This is how the patch should look when it is complete. |  |
| This hole was patched with FAST PATCH and must be filled on the front side. Bevel the surrounding plastic into the hole. |  |
| With a DA sander, remove the paint surrounding the damage and continue to radius into the hole. |  |
| This is a TPO bumper and fillers do not bond well to TPO unless an adhesion promoter is applied so, apply Filler Prep adhesion promoter to any exposed plastic. |  |
| Mix and apply Flex Filler to fill the hole and allow time for the filler to cure fully. While the filler is sandable in about 20 minutes, adhesion is not maximized until the filler is fully cured. This is especially important on TPO and polypropylene. It takes about 24 hour for the filler to cure fully but, you can speed up the cure time with heat. Full cure can be achieved in about 20 minutes at 140°F (60°C) |  |
| Sand filler flush and it is ready for primer and paint. |  |
 Click on image to enlarge |
Fast Patch
|
Products Used
Click on image to enlarge
2700-1
Fast Patch
$27.95
Click on image to enlarge
1060FP
Filler Prep
$8.95
Click on image to enlarge
2000-T
Flex Filler
$24.95
Facebook Fan Page
YouTube Channel
Add to TomTom